Roland VM-3100 General Setup of VM-3100Pro, RPC-1 card, and Recording Software
REGARDLESS OF SOFTWARE USED…set up the VM-3100Pro to work with the RPC-1 card and various recording software by using the following steps:
1. Reinitialize mixer to factory defaults, as per page 57 of the VM-3100Pro Owners Manual.
2. Press [SHIFT] & [F1] to “LOAD LOGIC CONFIG”*, then press ENTER/YES.
3. Press AUDIO CH button until it is green, then pull faders 13 though 20 (1 through 8) down, then back to 0 dB.
4. Press channel 13 SELECT button, and set PAN full left using V1 knob.
5. Press channel 14 SELECT button, and set PAN full right using V1 knob.
6. Press AUDIO CH button until red, then press LEVEL/METER to set parameters.
* This template is the only one that configures the mixer to route control and audio to and from the RBUS port, and should be used in conjuction with the RPC-1 card and various compatible software packages.
When you need help, Sweetwater has the answers!
Our knowledge base contains over 28,000 expertly written tech articles that will give you answers and help you get the most out of your gear. Our pro musicians and gear experts update content daily to keep you informed and on your way. Best of all, it’s totally FREE, and it’s just another reason that you get more at Sweetwater.com.
