Using the Line 6 TBP06 with older Relay G30 receivers.

Since the release of the XD55 series by Line 6, a second RF mode has been added. The newer systems now have a switchable RF mode between RF1 and RF2. By default, they ship in RF2 mode. If you have recently purchased a TBP06 transmitter and wish to use it with an older version of the Relay G30, you’ll need to set it to RF1. To do so, follow the instructions below:

TBP06 BeltpackTransmitter

• With transmitter off, set the Channel Select slide switch to channel 6.
• Turn on the transmitter.
• Immediately after the blue light blinks, slide the Channel Select switch completely left to channel 1 and back to channel 6. Do this 3 times total.
• This process must be completed within three seconds of turning on the transmitter.
• The blue LED will flash once to indicate that the transmitter is now in the 4-frequency transmission mode. To revert to RF2 transmission mode, repeat the above steps; the blue LED will flash twice when the transmitter is in this mode.

Note: It is IMPORTANT to note that once you shift (in either direction) the transmitters will only remember the change if you power cycle the transmitter. Just turn it off with the power switch and then back on. If you were to pop a battery before doing this then it will revert back to the last “saved” mode.

Knowledge Base