The expression pedals on my Behringer FCB1010 MIDI foot controller don’t work properly in Programming mode.

It is likely that the pedals need calibrated. Follow the steps below to calibrate the expression pedals on your Behringer FCB1010:

1. Turn on the FCB1010 while holding footswitches 1 and 3. When the display goes blank, release the switches. The FCB1010 will light up in sequence.
2. Once all the lights are on, press each Footswitch one at a time, including the UP and DOWN switches, until all the LEDs turn off. You will hear some mechanical clicks, and then the display will read “F1.”
3. Press the DOWN switch once.
4. Adjust the left expression pedal (A) to the lowest value (heel down), then press UP.
5. Now adjust expression pedal (A) to the highest value (toe down), then press UP.
6. Next, adjust the right expression pedal (B) to the lowest value (heel down), then press UP.
7. Finally, adjust expression pedal (B) to the highest value (toe down), then press up.
8. Reboot the unit.

Knowledge Base