How to install the soundware Objects?

Installing the Soundware Objects
The soundware objects are also part of the PC2 sound engine, so you’ll continue to use the
Install|engine in the boot block menu.
We’re assuming that you’ve just finished launching the boot block, and that the bottom line of
the display shows Install|engine . If instead you’ve just finished updating the operating
system software (and the display shows Install|engine|via|MIDI ), start at Step 3. If the
display shows Done , start at Step 4.
1. Press the Left or Right cursor button until you see Install|engine in the bottom line
of the display.
2. Press Yes. The display changes to Install|engine|via|MIDI .
3. Press Yes again. The display changes to Waiting|for|MIDI .
4. Using the sequencer or computer, find and open the basic objects file (pc2snnn.mid).
5. Play the MIDI file. The top line of the display shows SYS3-0|file|1|of|1 , and the
bottom line shows segment|1|of|13 . When the display shows Done , stop the
sequencer if it doesn’t stop automatically. As soon as you see Done , you can go on to the
next step.
6. If your instrument does not have the PCX-1 Polyphony Expansion option, your
installations are finished, and you can do the hard reset . If your instrument does
have the PCX-1 option, you’ll need to install soundware objects for the PCX-1 board.
Continue with Step 7.
7. Repeat Steps 4 and 5, but this time use the file pc2spnnn.mid.
8. Press Cancel to return to the boot block menu.
9. Do a hard reset, as described below.

Knowledge Base