How do I configure the CNTRL Key setup

SET CNTRL key: Pressing the MIDI/SELECT button and then the SET CTRL key will allow you to begin programming the rotary control knobs. In order to change the value of each knob (1 -8), you need to do as follows:

1.Press MIDI/SELECT,then press the Set Controller key (F3), marked “SET CNTRL.” The display will show a small “n ” to indicate that the desired controller knob “number ” should be entered next.
2.Choose the number of the desired controller knob using the number key group (1 -8).Then press the Enter key. The display will show a “P ” in anticipation of the “parameter ” number.
3.Assign the desired MIDI controller parameter number using the number key group (1-127),then press Enter.The display will show a “C ” in anticipation of the MIDI “channel ” number. See chart, “Appendix A.”
4.Assign the MIDI channel number on number key group (1-16)then press Enter. This channel assignment will apply only to the controller knob that you are programming. Finally, Press MIDI/SELECT key again to finish assigning values to the
controller knob.

Knowledge Base