How do I write to an existing program?

*****1st Memory protect must be off****then proceed and make your changes then

1) Select the Utility Menu command “WRITE PROGRAM” or “WRITE COMBINATION”
2) In “Catagory” specify the Category of the program/ combi
3) Use the “TO” to specify the bank and number of the writing destination
4) If you wish to change the name of the prog/combi press the F5 key and type your name…
5) After you have input the name press F8 key to go back to the Write page
6) To excute the Write operation press F8 again
it will ask are you sure? press F8 again…
and your done….

Knowledge Base