Updating the normal system data

You will need to obtain the set of three MS-DOS format
2HD floppy disks “System Boot Disk for KARMA Music
Workstation.”
1 Hold down the [ENTER] key and [LOCATE] key of the
KARMA music workstation, and turn on the power. The
LCD screen will indicate “Please insert System 1 disk.”
2 Insert the “System Boot disk No.1” into the floppy disk
drive of the KARMA music workstation. The system
will begin loading automatically, and the LCD screen
will show the following messages.
“Now loading…”
–
“Now erasing ROM”
–
“Checking the system’s check sum”
When “System Boot disk No.1” has finished loading, the
LCD screen will show “Please change to System 2 disk.”
If a disk error is displayed during this process, remove
the disk and turn off the power of the KARMA music
workstation. Then load the system again, starting from
step 1 .
While the system is being loaded, do not touch the
switches of the KARMA music workstation, and under
no circumstances should you turn off the power.
3 Remove the disk and insert “System Boot disk No.2”.
Messages will appear in the same way as for “System
Boot disk No.1.” When loading is completed, the
display will ask “Please change to System 3 disk.”
4 Remove the disk and insert “System Boot disk No.3”.
Messages will appear in the same way as for “System
Boot disk No.1.” When the system has been updated
successfully, the display will indicate “System was
completed,” and the system will start up automatically.
5 Turn off the power of the KARMA music workstation,
and then update the GE data.
After updating the system, you must also update the
GE data.

Knowledge Base