Trinity Series Importing the Effects from Combi Into the Sequencer

To Copy the Insert Effects
1) Press the COMBI button to enter the Combination mode.
2) Select the Combination you copied into the Sequencer mode.
3) Press the EDIT button to enter the Combination Edit mode.
4) Press the P7 button to enter the Effect Grouping page. You will notice that each of the 8 timbres has either a number, a leter “T-” with a number, or “OFF” next to it. These are the effects routings for the tracks. Make note of them.
5) Press the SEQ button to enter the Sequencer mode.
6) Press the P7 button to enter the Effect Grouping page. If the Combination was placed on tracks 9-16, touch the “Trk.9-16” tab, so that you are looking at effect settings for the tracks that the Combination falls on.
7) Usingthe value slider, wheel or buttons, select the noted variables for the tambre(s) as they appeared in the Combination Edit mode.

Perform the next steps for EACH of the timbres bearing a NUMBER ONLY for the routing:
1) Select the timbre.
2) You will see a new tab on the bottom of the screen bearing the number of the track followed by “FX”. Touch that tab.
3) Once in the effect select screen, touch the arrow on the top right-hand side of the screen.
4) Touch “Copy INsert Effects”.
5) Touch the arrow next to “From:”.
6) Touch “Combination” to specify that you wish to copy the effects from a Combination.
7) On the next line, using the value slider, wheel or buttons, select the Combination you previously copied into the Sequencer.

Importing the Effects from a Combi Into the Sequencer: Trinity Series (Continued)
8) Touch the number next to “Timbre:”.
9) Using the value slider, wheel or buttons, select the timbre (1-8) so that it matches the timbre you’re currently on.
10) Touch the box nest to “All” so that it is checked.
11) Touch “OK”
12) When asked “Are you sure”, touch “OK”. The effect parameters for the timbre you previously selected in step 9 have been copied to the timbre you are currently on.
13) Remember to repeat these steps for each of the timbres that show a number only for the routing.

To copy the Master Effects:
1) Press the SEQ to enter the Sequencer mode.
2) Press the P8 button to enter the Master Effects page.
3) Touch the arrow on the top right-hand side of the screen.
4) Touch “Copy Master Effects”.
5) Touch the arrow next to “From:”.
6) Touch “Combination” to specify that you wish to copy the effects from a Combination.
7) On the next line, using the value slider, wheel or buttons, select the Combination you previously copied into the Sequencer.
8) Touch the circle next to “All” so that it is filled.
9) Touch “OK”
10) When asked “Are you sure”, touch “OK”. The Master Effects parameters for the Combination selected have been copied to the Sequencer.

Knowledge Base