How to record your first track on a Roland VS2400 ?

To record in the VS2400 follow these steps…

Step 1.) Plug a Microphone or instrument into an input.

Step 2.) From your main screen push F1 (it should say “Input” above it… if it doesn’t push the Page button until it does).
The level meters on your screen now display the Inputs themselves.

Step 3.) While sending signal in, slowly turn the input knob (says “Line/ Mic” under it) clockwise. You will see level in the meter of the input you are connected to. Continue to turn the knob until the levels are between -4 and 0 in the meter.

Step 4.) Press F2 (IN Mix). Now we are looking at the levels of the Input Mixer. It is the Input Mixer that actually sends the audio to the record tracks.

Step 5.) Above your red Master Fader, push the button marked “IN 1-12”. We are now looking at the faders of the Input mixer.

Step 6.) Bring up the fader that correlates to the input you are using. (If you are using input 1, bring up fader 1, for example). You can use the Level Meters here to confirm that your levels are still passing through.

Step 7.) Press F3 (TR Mix). Now the level meters will show us what is being recorded to the Tracks.

Step 8.) Press TR 1-12. The faders are now operating in the Track Mixer mode.

Step 9.) Press the Track Status button for the track you want to record to, until it turns red. Since we are using the default routing, use the same Track # as your input. (If you are connected to Input 1, then push Track Status for Track 1) This puts the track into record status.

Step 10.) Push Record then Play.

Knowledge Base