How do I load a single Combi or Program?

A .PCG file is composed of many levels, actually like folders and files
nested inside each other. You can drop down level by level, and load
single banks of Programs and Combis, or even single Programs and
Combis one-by-one.
Let’s use an example where we load Combi B005 from disk, and place it
into location C020. The following example also applies to loading single
Programs; just substitute “Program” for “Combi.”
• (1.1-1) (Disk Mode) -> tab[Load]. Cursor to the desired .PCG file
containing the Combi or Program you want to load.
• Press the [F6] “Open” key to go down into the file one level. You will
now see the individual “folders” of Programs, Combis, Drum Kits, and
Global Settings. (Note: not all of these may be present, depending on
how the file was saved.)
• Cursor down so that the Combinations folder is highlighted. Press the
[F6] “Open” key to go down one more level. You will now see the
individual banks of Combis (which may be different depending on
what was saved into the file).
• Cursor to the bank of Combis containing the file you wish to load, i.e.
“(Cmb) Bank B”. Press the [F6] “Open” key again to drop down one
more level. You will now see the individual Combis within the bank.
• Cursor until the Combi that you wish to load is highlighted, i.e.
Combi B005. With B005 highlighted, press the [F8] button “Utility”
which comes up displaying “Load Selected.” Press [F8] “OK”.
• You will now get a dialog asking you to select the destination location.
Using the Bank Select Keys and the Rotary Data Wheel, select “C020.”
• Press [F8] to complete the load, or [F7] to Cancel.
To go back up the other direction through the levels, use the [F5] “Up”
key.
+ Parameter Guide, Pages 149-153.

Knowledge Base