How do I Route Parts Through the Direct Outputs Using an Insert Effect (EFX)?

In most synthesizers and/or sound modules, using direct outputs disables any internal effects processing before the signal passes through the outputs. This is fine when you are processing the signal with an external effects processor, but let’s say you wanted to use an internal effect and an external processor on the same signal; The JV-2080 allows you to route a Part through one of its insert effect processors before it passes through the direct output jacks. Use the following procedure to apply an insert effect to a Part and then route it through a direct output:

1. Press PERFORM.
2. Press F5[EFFECTS] to display the Effects page.
3. Press F6 until the General page (see Fig. 8) is displayed.
4. Use the CURSOR buttons to the select the “Output” parameter.
5. Use the VALUE dial to select “EFX-A,””EFX-B,” or “EFX-C.”
6. Press CURSOR RIGHT three times and CURSOR DOWN twice to select the EFX Output Assign parameter.
7. Use the VALUE dial to select DIR1 or DIR2 depending on which set of direct outputs you wish to use.

The selected Part will use an insert effect (EFX) routed through the direct output (1/2).

Knowledge Base