How do I record to the Stereo track on my AW4416HDCD?

Press the REC TRACK SELECT [ST] key.
The stereo track will be in record-ready mode.
Play back the song from the beginning, and watch the L/R level meter in the level meters/counter section.
If the red 0 dB segment lights, lower faders 1-16 and/or the STEREO fader.
After you have set the level, rewind the song to the beginning. Then hold down the Transport section [REC] key and press the [PLAY] key.
Recording on the stereo track will begin.
In order to create an audio CD (44.1 kHz), there must be at least four seconds of data in the stereo track.
When you are finished recording, press the [STOP] key.
To listen to the newly recorded stereo track, press the Recorder section [TRACK] key then the [F3] key.
The TRACK screen Stereo page will appear, allowing you to play back or erase the stereo track. When the AW4416 is in the initial state, the M (mute) button in the upper left of the screen will be turned on, muting the stereo track.
Move the cursor to the M (mute) button and press the [ENTER] key.
Muting of the stereo track will be defeated, allowing the stereo track to play back. At this time, the stereo track will automatically be assigned to monitor channels1/2, and the remaining monitor channels will be muted. If you play back the song in this state, the stereo track can be monitored via monitor channels 1/2 Õ stereo
bus.

Knowledge Base