QuickStart, Setting up a MOTU Digital Performer/Motor Mix System:

QuickStart, Setting up a
MOTU Digital Performer/Motor Mix System
1.) You will need a Digital Performer software version 2.7
or later.
2.) Connect Motor Mix MIDI IN and OUT to the MIDI OUT and IN on
one port of your functioning MIDI interface.
3) Make sure that the MotorMix is in “ProTools Mode” by pressing PLAY & ESCAPE on the right side of the unit. This will toggle it on and off.
4.) Launch FreeMIDI setup and choose “create device” from the configuration menu. Choose Mackie HUI” : (The HUI profile will work with the Motormix).
5.) Open a Digital Performer session and select “Control Surface Setup” in the Basics menu.
6) Select “HUI” in both fields of the “Control Surface Setup” window, and click OK.
7) Move a Motor Mix fader and the corresponding fader should
move in Digital Perfomer’s mixing board window
8.) Each time when you use Digital Performer you should have Motor Mix
powered up first to insure that Motor Mix gets a complete
update of your most recent session settings.

Knowledge Base