PCR-30/PCR-50: When I use pitch bend lever, it won’t reset to zero pitch. Why?

Here is how you re-calibrate the pitch bend and modulation:

Be very careful to follow these directions precisely.

1. Power On while pressing “L1” and “L3”.

2. Press “B4”.

3. Turn the bender lever to the left slowly and go back to the
center slowly, then press “B1”.

4. Turn the bender lever to the right slowly and go back to the
center slowly, then press “B2”.

5. Push the modulation lever to the end slowly and go back to the
center slowly, then press “B3”.

6. Verify the new bend range and modulation:
When full left, display should indicate 00.
When centered, display should indicate 40.
When full right, display should indicate 7F.
Push the modulation to the end, display should indicate 7F.

7. Press “Enter” and Power Off.

8. Again Power On and make sure that the DataOut LED turns on when
moving the bender and the modulation.

Knowledge Base