Naming and Storing

Storing (saving) is optional, of course. If you donÕt want to store any of your changes, press
Cancel one or more times to return to the mode you were in before you started editing.
Although naming is obviously optional as well, weÕll assume youÕre going to name the object
youÕre editing before storing it.
This procedure describes storing a setup, so it assumes that youÕre in MIDI Setups mode. The
process is similar for naming and storing other objects.
1. Press Store (in the Functions group of buttons). The display will show either
Save|Setup|NNN? or Replace|Setup|NNN? where NNN is the setup ID.
¥ If youÕre in the Internal bank of setups, the display will show Save|setup|NNN?
where NNN is the -rst available setup ID in the User bank of setups.
¥ If youÕre in the User bank, the display will show Replace|setup|NNN? where NNN
is the ID of the current setup. Use any data entry method to change the ID if you want
to save a new setup instead of replacing the current one.
2. Press > to display Rename|setup|NNN?
3. Press Yes (Enter). The display shows the name of the current setup, if any. The cursor
highlights the character thatÕs selected for editing.
4. Use any data entry method to change the current character. The alphanumeric buttonpad
is the quickest way. Press the corresponding button one or more times for the desired
characterÑfor example, press 1 three times for C. Use the UPPER/lower button to change
the case of the current character. Press 0 one or more times to enter numerals. Press the
cursor buttons to move the cursor to a different character. Press Clear to create a space
without moving the cursor.
Buttons SW1-SW3 have special functions when naming things. SW1 inserts a blank space
at the location of the cursor, moving everything after the cursor one space to the right.
SW2 deletes the character at the location of the cursor, and moves everything after the
cursor one space to the left. SW3 moves the cursor to the last character in the name.
5. Press Yes. The display again shows either Save|Setup|NNN? or
Replace|Setup|NNN? , depending on where you were when you started storing.
6. Press Yes (or press No if you donÕt want to store the setup after all). The display brießy
shows Setup|NNN|saved! then returns to MIDI Setups mode.
Special Characters For Naming Setups
Following is a list of all of characters available for setup names, in the order in which they are
found. The easiest way to get to them is to press one of the alphanumeric buttons to select a
character close to the one you want, then scroll to it with the alpha wheel. HereÕs the whole list:
! ” # $ % & ‘ ( ) * + , – . / 0 1 2 3 4 5 6 7 8 9
: ; < = > ? @ A through Z
[ \ ] ^ _ ‘ a through z (space)

Knowledge Base