Connecting Audio
Before you begin sequencing with the JV-1080, it is important to have the audio cables connected properly. Use the following procedure to setup the JV-1080 with a mixer:
1. Turn off the power on the JV-1080.
2. Connect two 1/4″ audio cables from the Mix Out L & R jacks on the back panel of the JV-1080 to channels 1 and 2 respectively on your mixer.
3. Pan channel 1 on your mixer all the way left and channel 2 all the way right to get the full stereo image. When you are using a mono signal connect the L (Mono) Mix Out to your mixer and pan the input channel on your mixer to the CENTER (12 o’clock) position. In addition to the Mix Outs, the JV-1080 has two additional stereo outputs that can be used for individual signal routing.
When you need help, Sweetwater has the answers!
Our knowledge base contains over 28,000 expertly written tech articles that will give you answers and help you get the most out of your gear. Our pro musicians and gear experts update content daily to keep you informed and on your way. Best of all, it’s totally FREE, and it’s just another reason that you get more at Sweetwater.com.
