Copying the Effects from a Patch to a Performance

The JV-1080 allows you to copy the Effects settings from a Patch to a Performance. This enables you to assign a Patch in a Part (Performance mode) the same effects settings as it has in Patch Mode. This includes the Reverb, Chorus, and Insert effects (EFX) with all their parameters. Use the following procedure to copy the effects from a Patch to a Performance:

1.Press UTILITY.

2.Press the RIGHT CURSOR button to select “COPY” (it will start to flash).

3.Press ENTER.

4.Press the DOWN CURSOR button to access the “PERFORM EFX COPY” screen.

5.Use the LEFT CURSOR button and VALUE knob to set the Source to “PATCH.”

6.Use the RIGHT CURSOR button to select the Patch displayed under “NUMBER”, and use the VALUE knob to select the Patch from which you wish to copy the effects.

7.Press ENTER to copy the effects from the Patch you’ve selected to the current Performance.

8.Press EXIT to return to Performance Play mode.

Once the effects settings are copied to the Performance we need to set the output of the Part to match the output settings of the Patch in Patch Mode.

1.Make sure that the PARAMETER, PALETTE, and EFFECTS (2/10) buttons are lit. Use the UP/DOWN CURSOR buttons to access the “OUTPUT ASSIGN” screen.

2.Use the LEFT/RIGHT CURSOR buttons to select the Part (1-16) that contains the Patch that was used as the effects source in step #6 above.

3.Use the VALUE knob to select PAT.

4.Use the DOWN CURSOR button to select “OUTPUT LEVEL” and use the VALUE knob to select 127.

5.Use the DOWN CURSOR button to select “CHORUS SEND” and use the VALUE knob to select 127.

6.Use the DOWN CURSOR button to select “REVERB SEND” and use the VALUE knob to select 127.

7.Press PALETTE (so it is not lit) and use the CURSOR buttons to access the “PERFORM EFX TYPE” screen.

8.Use the LEFT/RIGHT CURSOR buttons to select “SOURCE” and use the VALUE knob to select “PERFORM.”

Knowledge Base