How do I apply an effect to a sample on the Triton?

Applying an insert effect to the
audio input and sampling the
result
1 In step 5 of the preceding section “1. Connect a mic
and make input settings,” set the Input1 “Pan” to
C064, and “BUS” to IFX1.
2 Press the [MENU] key to access the Jump page, and
press P8: Insert Effect.
The P8: Insert Effect page will appear.
Press the Insert FX tab to access the Insert FX page.
3 Select “IFX1,” use the numeric keys to enter [5], [2],
and press the [ENTER] key to confirm 052: Reverb
Hall.
Press “IFX1 On/Off” to turn it ON.
4 Speak into the mic, and verify that reverb is applied
to the sound.
You can adjust the effect settings in the IFX1 page (IFX1
tab).
5 After pressing the [EXIT] key, press the Recording
tab to access the P0: Recording, Recording page.
6 Set “Sample Mode” to Stereo.
Now the sound of the internal LR channels can be sampled
in stereo.
7 Press the Create button to create a new index.
8 Press the SAMPLING [REC] key.
Press the SAMPLING [START/STOP] key, and speak
the word(s) that you want to sample.
Speak the word that you want to sample. (Example:
“It’s”)
Recording will start when the input exceeds the
“Level” -30dB level.
Press the SAMPLING [START/STOP] key to stop.
9 Play the keyboard.
When you play the “OrigKey” note, you will hear the
sound that was sampled.
Press the Clear button.
Press the Shift button to switch to uppercase letters,
and press S, M, P, L, -, and D in that order.
Press the Shift button once again to switch to lower-case
letters, and press e, m, and o in that order.
Press the OK button to close the text dialog box.
If you do not need to make any corrections, press the
OK button to execute “Rename Multisample” and
complete the procedure.
A stereo multisample will have a -L and -R displayed
at the end of the name, meaning that you will be able

Knowledge Base