“How do I split the K2600 into ZONES?”
Today’s answer provided by the Sweetwater Technical Support Department.
Step 1: choose whatever patch is your BASE/ANCHOR patch.
Step 2: hit the SETUP key
Step 3: hit the EDIT key – when you get to this screen you will be able to see ZONE 1 and all of its parameters
Step 4: choose the soft button KEYVEL
Step 5: the first 2 parameters you will see are Low Key and High Key. Now, if you are familiar with the key numbering system on your keyboard, you may select the area by dialing up each key with your jog wheel. If you are not familiar with the key numbers then go to step 6
Step 6: hit the left MORE soft button 2 times until you see the selection SETRNG.
Step 7: hit the soft button SETRNG – at this time, you will get a message that says “Strike low key” – You will strike the lowest key you want in your split. Then it will ask you to strike the highest key of the split (in other words the split point between both Zones). Once this is completed you will be taken back into the “EDITsetupKEY/VEL” page.
Step 8: you will hit the left MORE button 3 times until you see “NEWZN” (new zone)
Step 9: hit the soft button NEWZN and you are now on Zone 2 – Now continue steps 5-9 to create as many zones as you need then save.