How to Activate and Route the Inputs?

1. Pull down the Devices menu and select “VST Inputs”.
The VST Inputs window appears. This lists all audio inputs on your audio hardware, allowing you
to turn inputs on or off.
2. Locate the input pair to which you have connected your audio source, and make sure its
“On” button in the Active column is lit.
If not, click the button to turn the input on.
3. Close the VST Inputs window, and open the VST Mixer from the Devices menu.
This is Nuendo’s mixer window, used for setting levels, etc. The VST Mixer contains an audio
channel strip for each Audio Track in the Project window, so currently there will be a single
stereo channel strip.
4. Click on the arrow button at the top of the channel strip, to pull down the Input pop-up
menu.
This is where you select which audio input should be routed to the audio channel for recording.
5. Select the input pair to which you have connected your audio source.
Your audio source is now routed to the audio channel, so that it can be recorded on the Audio
Track.
Let the VST Mixer window remain open for now.

Knowledge Base