Discreet Stage Mic for Choirs, Orchestras, and More
The Audix MicroBoom MB5050 pairs a stand-mounted 50" MicroBoom arm with Audix's high-quality M1250 mini cardioid condenser mic. This unit makes a low-profile solution for overhead stage miking of orchestras and choirs, ambient miking, drum miking, and more. The boom in the MicroBoom MB5050 package can be used in either a horizontal or a vertical orientation. The upper end of the boom arm features a mini-XLR connector to securely hold the mic in place. The M1250 has a built-in low noise preamplifier, so no bulky external power supply is needed. If you want a clean, professional, and elegant miking solution, you'll find it in the Audix MicroBoom MB5050 from Sweetwater.
Related Videos: MicroBoom MB5050 50 inch Cardioid Mini Condenser Boom Microphone System - Black
Internal preamp delivers superb sound
The Audix MicroBoom M5050 with included M1250 condenser mic delivers superb sound. It has a fully integrated preamp and detachable cable, as well as strong shielding from interference. It's a solid overhead mic for choir and group vocals, on acoustic instruments, for ambient room miking, symphonic area miking, speech presentations, cymbals, and more.
Low-profile miking solution
The MicroBoom 5050 is an ideal solution for discreet stage miking. The 50" carbon fiber boom weighs in at just 2.5 ounces and attaches to any standard microphone stand. It uses a mini-XLR connector to hold the microphone securely in place. High-quality internal Mogami cable delivers excellent sound to the bottom of the boom, where a mini-XLR male connector keeps cables close to the ground.
Audix MicroBoom MB5050 Features:
- Low-profile stage mic for choirs, orchestras, and more
- Less than 0.3" in diameter
- Weighs just 2.5 ounces
- Generous 50" boom length
- Made of lightweight carbon fiber
- Attaches to a standard microphone stand (not included)
- Designed, assembled, and tested in the USA
Audix M1250 Condenser Microphone Specs:
- Transducer type: condenser
- Frequency response: 80 Hz–20 kHz
- Polar pattern: cardioid
- Output impedance: 150 ohms
- Sensitivity at 1k: 7.8 mV/ Pa (-42 dbV ±1.5 dB)
- Recommended load impedance: > 1000 ohms
- Signal/noise ratio (A-weighted): 73 dB
- Equivalent noise level (A-weighted): 21 dB
- Maximum SPL @ .5% THD: 150 dB
- Dynamic range: 129 dB
- Power requirements: 48–52 V
- Connector: 3 pin mini-XLRm
- Polarity: positive pressure on diaphragm produces positive voltage on pin 2 relative to pin 3
