Use the following procedure to update the operating system of the A-90\/EX through MIDI.<\/p>\n
Note: This procedure will erase the contents of the user memory of the A-90\/EX. As necessary, save the user memory to a memory card or to a sequencer via system exclusive before proceeding.<\/p>\n
1. Load the _00001.MID MIDI file into your sequencer.<\/p>\n
2.Power off the A-90\/EX.<\/p>\n
3. Connect \u00bc\u0094 cables to the HOLD and FS1 jacks of the A-90\/EX.<\/p>\n
4. Connect the MIDI OUT of the sequencer to the MIDI IN2 of the A-90\/EX.<\/p>\n
5. While holding down the OUT 1 button, turn the power on.<\/p>\n
6. The LCD should display \u0091UPDATA [******-*].\u0092<\/p>\n
7. Playback the first .MID file (_00001.MID).<\/p>\n
8. After the sequence has completed playback, press ENTER on the A-90\/EX.<\/p>\n
9. After \u0091B1: CE9A Update?\u0092 is displayed, press ENTER again.<\/p>\n
10. After \u0091Erase -> Write -> CE9A-CE9A OK\u0092 is displayed, press ENTER.<\/p>\n
11. Repeat steps 8-11 with MIDI files \u0091_00002 – 00008.\u0092<\/p>\n
12. After the last file has been completed and verified, turn off the A-90\/EX.<\/p>\n
13. Hold down the MANUAL button and turn the power on to enter the Factory Reset mode.<\/p>\n
14. Press ENTER to complete the initialization.<\/p>\n
NOTE: If you are not able to operate the BENDER\/MODULATION lever after following the above procedure, you may need to reassign this controller to its initial settings. Use the following procedure:<\/p>\n
1. Press EDIT so that it is lit.<\/p>\n
2. Move the BENDER\/MODULATION lever to the right and use the VALUE INC\/DEC buttons to select \u0091Ch.M > PITCH BEND.\u0092<\/p>\n
3. Move the BENDER\/MODULATION lever forward and use the VALUE INC\/DEC buttons to select \u0091CC > MOD :1.\u0092<\/p>\n","protected":false},"featured_media":0,"template":"","categories":[],"tags":[],"storecat":[],"itemids":[],"manufacturers":[33684],"acf":[],"yoast_head":"\n\n\n\n\n\n\n\n\n\n\n\n\t\n