Often, it is desirable to use Patches in Performance Mode and have them sound exactly as they do in Patch Mode. The JV-2080 allows you to copy the effects settings of a Patch to a Performance. This enables you to replicate the reverb, chorus, and insert effect (EFX) settings from Patch Mode in your Performance. Use the following procedure to copy the effects settings of a Patch to a Performance: <\/p>\n
1. Press UTILITY.
2. Press F2[COPY] to select the Copy function.
3. Press F2[EFFECT] to select the Effect Copy page (see Fig. 7).
4. Use the CURSOR buttons to select the “Source” parameter.
5. Use the VALUE dial to select “PATCH.”
6. Use the CURSOR buttons and the VALUE dial to select the Patch from which you wish to copy the effects.
7. Use the CURSOR buttons to select “Copy Type.”
8. Use the VALUE dial to select “ALL.”
9. Press F6[EXECUTE] to copy the effects from the selected Patch to the Performance.
10. Press EXIT twice to return to Performance Play Mode. <\/p>\n
Fig. 7
Effects Copy Page<\/p>\n
Once the Patch effects settings have been copied to the current Performance, we need to ensure that Patches assigned to the desired Parts are routed to the various effects processors just as they would be in Patch Mode. This is determined by the Output Assign setting for each Part in the Performance. An Output Assign setting of “Pt” (A, B, or C) indicates that the Patch assigned to that Part will determine the EFX settings for the corresponding processor (A, B, or C). Up to three Parts can be routed this way. Use the following procedure to set the output assignments for a Part: <\/p>\n
1. Press F5[EFFECT] to display the Effects page.
2. Press F6[PALETTE] to view eight parts simultaneously.
3. Use the CURSOR buttons to select “Output Assign” for the desired Part.
4. Use the VALUE dial to select “Pt-A.”
5. Use the CURSOR buttons to select “Output Level.”
6. Use the VALUE dial to select “127.”
7. Use the CURSOR buttons to select “Chorus Send.”
8. Use the VALUE dial to select “127.”
9. Use the CURSOR buttons to select “Reverb Send.”
10. Use the VALUE dial to select “127.”
11. Press F6[PART 1] to return to the single Part view.
12. Press F1[GENERAL] to select the EFX Information editing page.
13. Use the CURSOR buttons to select “EFX-A.”
14. Use the VALUE dial to set the EFX-Source to “PERFORM.”
15. Repeat steps 3-14 for any two additional Parts using “Pt-B” or “Pt-C” as Output Assignments. <\/p>\n","protected":false},"featured_media":0,"template":"","categories":[],"tags":[34715],"storecat":[],"itemids":[],"manufacturers":[33684],"acf":[],"yoast_head":"\n\n\n\n\n\n\n\n\n\n\n\n\n\t\n