Once you’ve routed a Part to an effects processor, you can choose the type of effects you would like to use. <\/p>\n
1.Press PALETTE, so it is not lit. <\/p>\n
2.Make sure that the PARAMETER and EFFECTS (2\/10) buttons are lit. Use the UP\/DOWN CURSOR buttons to select the “PERFORM EFX TYPE” screen. <\/p>\n
3.Use the VALUE knob to select the desired Insert effect. Make sure that “PERFORM” is selected under “Source.” Keep in mind, you’ll only hear this effect on the Parts that have their output assigned to EFX in the previous steps. <\/p>\n
4.Press the DOWN CURSOR button until you get to the “PERFORM EFX OUT” screen. Here, you can select the output routing for the Insert effect (and subsequently the Parts whose outputs you’ve routed to EFX) and the overall output level. Use the RIGHT CURSOR button and VALUE knob to adjust the amount of Chorus and Reverb applied after the Insert effect. <\/p>\n
5.Use the DOWN CURSOR button to access the “PERFORM CHORUS” screen. Here you can adjust the Chorus parameters to make it suitable for your Performance. <\/p>\n
6.Use the DOWN CURSOR button to access the “PERFORM REVERB” screen. Here you can select a Reverb type and adjust the various parameters as desired.
NOTE: Since a Performance allows you to use 16 different Patches at once, you may want to alter the amount of effects (Chorus and Reverb) on a given Part to suit the sound (Patch). Use the procedure on Page 8 to change the effect level individually for each of the Performance Parts. The Insert effect level will be controlled globally by the Level parameter in the” PERFORM EFX PRM” screen for all Parts whose outputs are set to EFX in the ” PART OUTPUT” screen. <\/p>\n","protected":false},"featured_media":0,"template":"","categories":[],"tags":[34355],"storecat":[],"itemids":[],"manufacturers":[33684],"acf":[],"yoast_head":"\n\n\n\n\n\n\n\n\n\n\n\n\n\t\n