View Full Version : K2000/K2000R Pram install
10-21-2003, 09:32 PM
I have bought PRAM for my K2000 keyboard without any instructions for instalation.Also I found answer how to install it but the new qestion comes like this.Is this Pram is for Kyeboard or for Rack version?I think is not the same stuff.Can I install it into a keyboard, if this Pram is for Rack?
Thanks in advance!
They are the same, but installation can be quite difficult depending upon which revision of motherboard you have. Unless you are an experienced tech you should take it to an authorized repair center.
10-22-2003, 11:46 AM
Thanks for answer.It´s no possible to take it to autorized center because in Bulgaria have not.I have to do it in myself.How to understand wich revision of motherboard I have and where is different ?.This is Calvin board,original OS 1.3,upgraded to 3.87 but dont know enything about revision.If I do it like this:solder the white wire to negativ leg of diode D1 and solder green wire to Audio Board Link pin 2,should I expect trouble?
From my memory it sounds like you are on the right path. It may be worth a phone call to Kurzweil to get them to confirm. It's also possible they will sell you a service manual, or maybe even fax you the install instructions, which I believe addresses most of the differences in major revisions. They can be surprisingly cooperative with things like this.
10-23-2003, 07:36 AM
I´ll be very glade to have the service manual but dont think they will sell me.So,I´ll try with them.Thanks for reply.
04-01-2004, 02:26 AM
I bought a used K2000, opened it up and discovered that the WHITE wire (from the PRAM plug) had come unsoldered... Please if anyone has an installation kit's instructions or can email me a photo of WHERE this wire is supposed to go, I appreciate it much!
Powered by vBulletin® Version 4.2.1 Copyright © 2013 vBulletin Solutions, Inc. All rights reserved.