Dloving
10-26-2002, 10:15 AM
1.How do you split a track in Phrazer so that there is a break . Ex. track 1 is a drum riff and I want there to be a break where a fill (from another track will go). In acid you can click on the track, right click and use split points. then you can drag the track apart like you want it. I think this is done in the editor at the bottom, but I have not been able to figure it out yet.
2 .I figured out how to add an effect to a individual track, but how do I set the effect to take place at a certain point in the track ( like a delay), but not through the entire track?
3. same quesstion as it relates to pan and volume. In acid you can click on the track and set volume and pan points. If I wanted to slowly lower the volume of a track or set pan points, where do I go in Phrazer?
I bought Phrazer after working on a friends PC using acid. I figured they would be alot alike. I was wrong. Any suggestions would be a great help. The on-line manual does not go into great detail about these issues-DL
2 .I figured out how to add an effect to a individual track, but how do I set the effect to take place at a certain point in the track ( like a delay), but not through the entire track?
3. same quesstion as it relates to pan and volume. In acid you can click on the track and set volume and pan points. If I wanted to slowly lower the volume of a track or set pan points, where do I go in Phrazer?
I bought Phrazer after working on a friends PC using acid. I figured they would be alot alike. I was wrong. Any suggestions would be a great help. The on-line manual does not go into great detail about these issues-DL