ADAT lightpipe addon

[Stonie]

Hi all,
I got an 01v today with the ADAT lightpipe addon. I am running adat in and out to the 828 and set everything up in nuendo. I cannot get a record signal at all!

Please help me. I feel sure it is some kind of sync issue?

Thanks ALL!

[David Klausner]

If you're not getting any signal at all, I'm not sure it's a sync issue. Have you gone into the control panel for the 828 and selected the lightpipe inputs and outputs? If you haven't, then launch the control panel and select them - that may be your problem right there. Once you have done that, the only sync to consider is word clock, which if it is set incorrectly, will give you all kinds of pops and clicks, but should still let the signal pass. I would probably set the O1V to be the clock master. It should by default be on its own internal clock, so you shouldn't have to change anything there. In the control panel for the 828, you should be able to select ADAT optical in for a clock source (but only after the inputs have been activated). Hope this helps...