Psuggars
06-24-2002, 06:35 PM
Hi,
I am using Logic 5 on a shiny new G4 Powerbook (666Mhz) with 30Gb internal HD and 512Mb of memory.
I am using the built in Mac AV system to provide an audio engine on the laptop, but keep running into the following problem when I have more than a couple of plug in's inserted (Evoc, EXS24 e.g.) into the chain playing single stero audio track.
"Mac AV:
System Overload
the audio engine was not able to process all required data in time
(-10011)"
After looking at the install manual I have activated the "Larger Disk Buffer" option from Audio->Audio Hardware and Drivers Menu, but this hasn't had any affect.
I am new to using Logic so I am at a bit of a loss where to start looking for the cause of the problem. Any pointers or suggestions would be greatly appreciated.
Gracias y Saludos
Felipe
I am using Logic 5 on a shiny new G4 Powerbook (666Mhz) with 30Gb internal HD and 512Mb of memory.
I am using the built in Mac AV system to provide an audio engine on the laptop, but keep running into the following problem when I have more than a couple of plug in's inserted (Evoc, EXS24 e.g.) into the chain playing single stero audio track.
"Mac AV:
System Overload
the audio engine was not able to process all required data in time
(-10011)"
After looking at the install manual I have activated the "Larger Disk Buffer" option from Audio->Audio Hardware and Drivers Menu, but this hasn't had any affect.
I am new to using Logic so I am at a bit of a loss where to start looking for the cause of the problem. Any pointers or suggestions would be greatly appreciated.
Gracias y Saludos
Felipe